Highlight: Static balance valve brass threaded thread

Product introduction:

For static imbalance problems, installing a balance valve in the system and debugging it with a dedicated intelligent instrument can solve the problem Effectively eliminate the residual pressure head of certain loops, so that the flow rate of each loop can meet the design flow rate. A balance valve is a special function valve that has good flow regulation characteristics, with a linear relationship between relative flow rate and relative opening. There is a precise valve opening indication, with a minimum reading of 1% of the valve's full opening. There is a reliable opening locking memory device that can restore the valve to its original locked position after a change in opening. There is a shut-off function, and once a balance valve is installed, there is no need to install a shut-off valve again. There are quantitative measurement and adjustment functions. During system debugging, the debugging personnel can adjust the balance valve through human-machine dialogue with specialized intelligent instruments to achieve hydraulic balance of the system.

Product technical parameters:

Product features:

1. Before and after the static balance valve, sufficient length of branch pipe sections must be installed to ensure the rated output of the flow rate.
2. The installation position of the static balance valve should be checked according to the drawing, and it is recommended to install it on the HVAC system return pipeline. At the same time, the direction of water flow in the pipeline should be checked, and the installation should strictly follow the direction of the water flow arrow on the valve body.
3. Before installing the static balance valve, the pipeline debris must be cleaned thoroughly. It is strictly prohibited to leave welding slag, branches, stones, and other debris in the pipeline to avoid damaging the valve.
4. During the welding of pipeline flanges, excessive deformation and welding angles should not affect the flatness of the sealing surface.
5. After installation, the static balance valve should be fully opened to allow for repeated flushing of the pipeline until it is clean. It is strictly prohibited to repeatedly close the valve during pipeline flushing to avoid damage.

Our Advantages: