Highlight: Digital locking hydraulic flow control cut-off valve, low-temperature threaded thickened brass static valve

Product introduction:

The new digital lock balance valve produced by our company is a new type of energy-saving valve with special functions. As the valve is provided with digital display and digital locking device, can be directly adjusted to any position, and pressure measurement valve for flow measurement. This valve is mainly used in industrial and civil building heating pipe network system, has the good flow characteristic, can adjust the pressure drop and flow rate accurately, can reasonable distribution of flow, implementation flow quantitatively, can effectively solve the heating (air conditioning) to room temperature uneven and the problems existing in the system, as long as in the selection and user entry fitted with appropriate specifications of digital locked balance valve, And a special intelligent instrument for one-time debugging after locking, the total water control system in a reasonable range, so as to overcome the "large flow, small temperature difference" unreasonable phenomenon. Therefore, this product is an ideal product in heating system. The application of this valve can achieve the dual effect of liquid balance and energy reduction in pipe network.

Product technical parameters:

Product features:

1. Before and after the static balance valve, sufficient length of branch pipe sections must be installed to ensure the rated output of the flow rate.
2. The installation position of the static balance valve should be checked according to the drawing, and it is recommended to install it on the HVAC system return pipeline. At the same time, the direction of water flow in the pipeline should be checked, and the installation should strictly follow the direction of the water flow arrow on the valve body.
3. Before installing the static balance valve, the pipeline debris must be cleaned thoroughly. It is strictly prohibited to leave welding slag, branches, stones, and other debris in the pipeline to avoid damaging the valve.
4. During the welding of pipeline flanges, excessive deformation and welding angles should not affect the flatness of the sealing surface.
5. After installation, the static balance valve should be fully opened to allow for repeated flushing of the pipeline until it is clean. It is strictly prohibited to repeatedly close the valve during pipeline flushing to avoid damage.

Our Advantages: